The water pumps will likely last for a long time if you do minor repairs when they are necessary. You will also be able to make the unit work properly. Here are some repairs that you can do to fix your water pump.
Some important points to look while replacing the pumps
- Remove the bolts on the lower part of the unit while doing 15 Hp Evinrude Water Pump Replacement. To do this, you need a wrench. You will find that the size of wrench you need depends on the brand of the outboard motor. In this case, each bolt will be the same size.
- The trim tab is located on the propeller. You will find that it is bolted through the trim tab. Make sure you separate the bolt and the tab after you have removed the trim tab.
- As you do this, make sure that the lower unit is free from the motor. When you do this step, make sure that the lower unit is free from the motor.
- After removing the lower unit, expose the motor and shift shafts. Remove them with gentle pressure and slide them out.
- Make sure you handle the bolts carefully so they do not break due to corrosion. Once the bolts are removed, you will be able to lift the casing easily.
- Slide the impeller of the pump over the motor shaft. Remove the steel plate and gasket attached to the impeller.
- Remove the "o" ring and stainless-steel cub from the casing. Also, remove the key way from the shaft by using a standard screwdriver in a top-down motion.
- Start installing the new parts of the water pump kit. Lay them neatly before installing. Replace the gasket over the steel plate of the pump in the original place. Be sure that the gasket is put over the steel plate and is properly fitted. Once the key way is installed, locate the small indentation on the impeller and align it.
- Next, you should place the "o" ring outside the edge of the cap. Next, put the new stainless in its place inside the casing. Then slide the "o" ring and the stainless cup over the shaft to the impeller and turn it clockwise. When you turn the motor shaft, make sure the plastic cap is pressed down. Grease the bolts that you removed to secure the casing.
- Lubricate the bolts used to replace the tops of the shift shafts and the motor.
- Using two holes in the middle of the motor, reinstall the lower unit so that your outboard motor pool pump can be used.
Where to get the best kits for replacement?
As you are now well aware of how to fix the water pump but still you need the proper kits to do so and for that you can visit impeller feller, they are amongst the best stores that provide top quality water pump replacement kits and Suzuki 6hp outboard and many other kits which you can buy depending on your needs.
So, what are you waiting for visit them now by clicking the link below,
https://impellerfeller.co.uk/ .
